Creator 5 auxiliary-fan preset revision V2: all four slots explicitly use the same embedded aux-off inherited preset. Open as a project and re-slice; changing presets can restore their values. Other settings and original geometry are unchanged. No fresh GUI/slice/physical fan-behaviour proof is claimed.

Open the 3MF as a project; keep seven colour regions aligned. Print at 100% in millimetres, upright in supplied pose. Creator 5 auxiliary cooling speed zero in every saved filament slot; part cooling/exhaust unchanged. Recheck after preset changes, then re-slice. Supports, closing layers, slot braces, hinge gaps and prime tower paths need fresh review. Prefer the native project: the ASCII17 whole-book STL preserves exact approved geometry but inherits microscopic near-coincident/collinear triangles and float32-read warnings. Inspect any repair against the native before printing. STLs contain no colours or fan settings.

Cool completely, gently free the cover and do not force fused joints. Check closure, legibility and slot/drop/retrieval clearance on your print. Dry-fit optional magnets, check polarity and securely retain; keep loose magnets/small parts away from children and pets. Reset by removing stored pieces and closing the book. This optional storage/display sidequest is not required Apprentice progression.
